O.k. so I tried CATS & it unlocks fine & identifies calibration & doesn't identify VIN but ignore that & go to program & get a similar programming error & retries 3 times & then gives up, I then tried Fermec software for eeprom area & immo & just show's 00 for all...

So it's a bit weird as 1 of the 3 ecu's literally only has a speed limit change & others are similar so I don't think they were intentionally locked, where the supposed seed/key is in all of them is around where VIN is supposed to be but all 3 are hyroglyphics & I think they may have just ha...

Yeah it’s a bit strange, I have 3 of them that had been tunerlocked & then were brute forced to find correct key which on all three were the same as seed, then they had the correct key written & then try to read or write in anyway it responds 7F negative response code… so hence looking for s...

Yeah it seems the ponyprog is better than gq4 with eeprom write stuff like this… but also need to have a good quality aligator clip!

Ok so I know I was able to hot swap 1 of these ecu’s but to save the risk if there is a communicative e38 on the same comm bus of a non-responsive e38 will it write the same file on other PCM if branched together?

As far as programming with all this stuff works I’ve been too reluctant to jump in to the shark pool… but the FEPS that needs crazy voltage jump hasn’t been needed when I tested read/write on bench but I’m sure I’ll be told that I’m in-correct!

WOW this is a pretty cool tool, I've never had the need for it but I'm sure it will come in handy to plenty of people & maybe me someday too!

Hello You need to increase Lambda values to get less smoke. FMTC_trq2qBas should extend torque axis, because of request in Torque limiter. You don´t need to modify SOI maps at this moment. Just for reference with extending the torque axis how does this happen as with diesel & general rule of th...

Excellent, o.k. that seems back to front to me, but I'll give it a go... I was told because the drivers wish was adjusted below 2000rpm is why it was smoking so much so any tips & advice is appreciated!

I'm pretty sure there was a beta test for the memcal based $A5, but other than that yeah up to the 424 ecu... there's a few other things that can be done too.

Whats the main advantage in your opinion of MAP over MAF?