It might be a while before I get the knock sensor comparisons as my stock transmission is acting like it has a 4000rpm stall converter in it just a little bit of slip

Oh ok i see now if i play the log at 400% speed it shows 40Hz if only i could log at that
Thanks

I normally see 15hz recording speed and up to 30hz with message 6 logging. Nice :thumbup: Im using 11p, Is Message 6 Logging the same as Messagge 11 in 11P? Time to do some more reading and get my head around how to set it up properly as it only has knock counts and i defenitily need Knock Retard V...

The average logging speed is around 10Hz while recording but when i play back the log. pause it and jump forward samples using ] short cut key on the keyboard and look at the Hz reading its around 3Hz logging speed is this normal because it is recording all data. I will try tweaking the adx and see ...

VL400 wrote: Lets say you are logging at 10Hz, or 100ms between logging frames. Knock counts are a delta count over a 12.5ms period, so with 100ms gaps between logging frames there are 8 delta count calculations which you missed 7 of. If only one of those 8 had some delta counts (which would then p...

Thanks for the explination. VL 400 I will see what i can do about loging the different sensors i have 100k sensor in the right side and 4k sensor in the left both are wired back to ecm just have to plug in the one i want to read.

Thanks for the replys, I have put a vr 4k knock sensor in now so it matches. now i understand why there is no knock history logging. This is not my engine just curious how 11P does this. lets just say any engine running 11P @ 2000rpm-90kPa 22 deg advance, detects knock counts and retards the timing ...

I might screw in a 4k one on the other side if the engine just for comparing. Its not throwing code 43 at all. i was just confused when the knock counts were high and each time i turend off the engine and restarted it they would change. Its good to know this is all normal i havent used 12p or 11p be...

I'm not sure whats going on. I have just put a vr loom and auto transmission in my vs ute and im running, 11P it seems to be running fine drive ability wise but when i installed a HSV vs manual memcal on the side of the nvram and enabled , Knock Sensor Installed Option. The knock counts are high on ...

Mr Newman made sure there will be no riots when he introduced the new bikie bill, check out the definitions of a the act 3 or more people fighting for the same thing can be charge with it.
https://www.legislation.qld.gov.au/Bill ... DisB13.pdf