Spark only bin to turn 808 into programmable ignition ecu

[Jayme]

I did a very similar setup on my motorbike engine, only difference is I had the MAT sensor hooked up. the CEL light worked fine. I used the wiring pinouts from the holden workshop manual and made my loom from scratch, didnt even bother putting in a pin for the stuff I didnt hook up.

[yoda69]

All sorted.
Went and pulled out the memcal, erased and re burnt and set $5D to $AA, even though checksum should have been fine, will look into this more later.
Must have had something corrupted as now working fine.
Got lucky with the DTC's, went through originally and turned off everything I wasn't using, which was probably about all of them, only flashing DTC12.

Thought when I wired on the OBD2 connector I may have made an error, I also wired in a switch that has 3 positions, middle is nothing, left is 10K between A&B and right is a short between A&B.
Saves me having to look for a paperclip and 10k resistor everytime I want to do something.
Vehicle had a spare lamp in the dash that is not used so wired this up for CEL.
Car is idling with a MAP value of around 25kpa.
ECT and MAT (inlet in my case as it is mounted in the air cleaner) both working.

Thanks everybody for their help.

yoda69

[Holden202]

great news on the resolution!

thats a pretty good vaccum at idle

i did a similar thing with the diag wires in my gemini cause when i start drag racing i don't want to have to remember to take a paper clip to the drag strip!

have you played with timing at all yet ?

[yoda69]

She's old and tired.
Stock cam that is probably fairly worn and and retarded with chain stretch, explains why it won't pull much past 4000RPM.
I'm using the non ported pick up of the base of the carby, will try and T into the one off the back of the manifold for the power brakes and auto tranny and see if it any different there.

Haven't had a chance to play with the timing yet, but did do a check with the Ostrich and stacked bin, and all worked fine.
Will at least be able to datatrace and see what cell I'm in.

yoda69