Hi guys
I'm am wondering if someone can point me in the rite direction to get communication with my tuning setup.
Vehicle is a VS Statesman 5.0lt Auto
Realtime PCM with the Nvram. Dallis Chip.
Programed with no offset vehicle starts and runs.
New ALDL interface and cable purchased as I suspected my others may have been letting me down.
Tuner Pro RT version is 5.00
ADX $11B and ive tryed p
XDF $11B
I feel like I am close but something obverse is stopping me from detecting the hardware.
Cable Echo is ticked in the plugin settings menu.
Com port is correct.
OSE Plugin is used.
Can someone assist me with this issue.
ALDL interface conunitcatioin to NVRAM issues
- antus
- Site Admin
- Posts: 8265
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: ALDL interface conunitcatioin to NVRAM issues
You should be using the ADX and ADX from the 11P zip (look for the link in the FAQ area, link up near top right).
But even without that it should detect. When you say runs, is the car stock? Does it run well enough that you think the nvram is running the car and it is not in limp home backup mode?
But even without that it should detect. When you say runs, is the car stock? Does it run well enough that you think the nvram is running the car and it is not in limp home backup mode?
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
-
- Posts: 2
- Joined: Tue Jul 09, 2019 11:14 am
- cars: R35 GTR
R34 GTR
AUDI R8
R33 GTST
R33 GTST
R32 GTST
Re: ALDL interface conunitcatioin to NVRAM issues
Hi Antus.
Yes that is the VR_ $11_v1.01 i am using.
Engine is modified with cam mild cam. Vehicle starts and runs fine and is not in limp mode.
I have gone though all of Ashley's Folders and confirmed that all the jumpers and Chip is programmed properly.
Can the Dallis Chip allow the vehicle to run but not accessed somehow?
It must to be an issue with Config........ I have tested and tried different config set ups and different versions of tuner pro still having the same result.
Im not sure what to do next.
Yes that is the VR_ $11_v1.01 i am using.
Engine is modified with cam mild cam. Vehicle starts and runs fine and is not in limp mode.
I have gone though all of Ashley's Folders and confirmed that all the jumpers and Chip is programmed properly.
Can the Dallis Chip allow the vehicle to run but not accessed somehow?
It must to be an issue with Config........ I have tested and tried different config set ups and different versions of tuner pro still having the same result.
Im not sure what to do next.
- antus
- Site Admin
- Posts: 8265
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: ALDL interface conunitcatioin to NVRAM issues
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396